RE300 not joining Mesh

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE300 not joining Mesh

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
RE300 not joining Mesh
RE300 not joining Mesh
2023-12-22 23:27:14
Model: RE300   Archer C80   RE315  
Hardware Version:
Firmware Version:

Hi

 

I'm running a Mesh network with a C80 router. I have RE300 and RE315 extenders

 

The RE315 successfully shows up in the tether app as a satellite device under the C80 Easymesh settings. Roaming between device seems fine too.

 

The RE300 is the problem. It extends the C80 network fine and it has the mesh settings on. However it won't show up under the C80 Easymesh settings as a satellite and devices won't roam easily. Usually I have to switch my phones wifi off and on again to swap between C80 and RE300 (and vice versa).

 

Tried adding the RE300 to the Easymesh via WPA but no luck either.

 

Any ideas how to truly get the RE300 operating as part of the mesh properly?

 

  0      
  0      
#1
Options
1 Reply
Re:RE300 not joining Mesh
2023-12-23 01:38:21

  @Artemis123 

 

Look at the sticker of your RE300 to check if it's with the EU region FW and for its HW version first - details.

Make sure that you're with the latest FW release for RE300 - here. That would be version RE300(EU)_V2_1.0.13 Build 221216 that supports Easymesh (for EU region).

Building Easymesh using the WPS method is descried here (Method 2).

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  1  
  1  
#2
Options

Information

Helpful: 0

Views: 516

Replies: 1

Related Articles