DHCP settings for Guest Networks?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

DHCP settings for Guest Networks?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
DHCP settings for Guest Networks?
DHCP settings for Guest Networks?
2023-12-24 20:29:15
Model: Archer VR2800  
Hardware Version: V1
Firmware Version:

Hello,
I moved to FTTH recently. And now I have another router as my main router.

The VR2800 is repurposed as an AP and so far it seems that it's doing its job well. I still haven't check if it's using double NAT, although I doubt.

 

However, my main issue is that clients of the guest networks cannot access the Internet and this is a huge issue for me. How can I configure the Guest Networks to use a different subnet than the main Wifi networks? The main router allows me to use a different subnet/VLAN and obviously I want to use this functionality!

  0      
  0      
#1
Options
2 Reply
Re:DHCP settings for Guest Networks?
2023-12-25 17:15:04

  @PeterTselios 

 

Here's how to configure VR2800 in AP mode. This will guarantee that there's no double NAT introduced.

As for the VR2800 guest network - better use only your main router one. I doubt that when VR2800 is in AP mode its guest network would be usable.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options
Re:DHCP settings for Guest Networks?
2023-12-25 18:04:20

  @terziyski probably 😐

  0  
  0  
#3
Options