Home Network Community > All Threads > Swapping to X75 - tips?
< All Threads

Swapping to X75 - tips?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Swapping to X75 - tips?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Swapping to X75 - tips?
Swapping to X75 - tips?
2023-12-26 12:53:59
Model: Deco XE75  
Hardware Version:
Firmware Version:

Have decided to swap over to Deco XE75 mesh. Currently on Netgear RBK353 Mesh. Planning to use base + 1 satellite (2700sq. ft home)

 

I want to retain the current attached devices (without having to reset them again).

 

  1. Apart from using the same SSID and the Password, do I also keep the WPA2-PSK(AES) the same?
  2. Should I consider 3 units system instead of 2?
  3. Currently I have 6 attached devices with Fixed ip addresses). Will these be retained after swap over?

 

Any other thoughts will be appreciated.

 

 

 

  0      
 
  0      
 
#1
Options
2 Reply
Re:Swapping to X75 - tips?
2023-12-27 06:05:18

  @wizzard1 

Hi, 

The default wireless security mode on Deco XE75 is also WPA2 so the wireless security would be the same as Netgear before.

If the house are separated by multiple rooms/walls, it would be better to have 3 units.

And since all Deco Mesh works together. You could also start with 2 units and add additional Deco later if needed.

The default LAN IP range on Deco is 192.168.68.xxx. I think it might be a problem for the reserved IP devices.

You might need to either change the default LAN IP address or re-configure the reserved IP addresses on the devices.

Thank you very much and best regards.

 

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options
Re:Swapping to X75 - tips?
2023-12-27 11:51:48

  @David-TP 

 

Thanks a lot for the detailed response which makes things much clearer.

 

One further issue, assuming I keep the default 192.168.68.xxx range AND use Netgear SSID and password, will all the current devices still connect automatically?

 

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 462

Replies: 2

Related Articles
Deco X75 Broadcasting strange network SSID
254 1
Matter and Thread Support - X75
567 3
Deco X75 cannot connect to internet
475 1
swapping Deco E4 main for M4
1022 0
Deco X75 Pro
565 0
Swapping an existing Mesh network over to full fibre
501 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.