TL-WR902AC - client mode - wpa2 personal

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-WR902AC - client mode - wpa2 personal

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WR902AC - client mode - wpa2 personal
TL-WR902AC - client mode - wpa2 personal
2024-01-11 16:23:05 - last edited 2024-04-02 09:23:06
Model: TL-WR902AC  
Hardware Version: V4
Firmware Version: 0.9.1_0.3

Hello,

 

while following the steps to setup the router in client mode, the quick-setup wizard is unable to detect the network.

 

The network I am tryung to connect is based on 'WPA2-Personal'.

 

I tried resetting the router, but that didn't help.

 

Any suggestions? Thank you in advance for your time and response :)

  0      
  0      
#1
Options
1 Reply
Re:TL-WR902AC - client mode - wpa2 personal
2024-01-11 18:09:38

  @CeeSharpDev 

 

Hi,

 

In case the wireless network you are trying to connect to is operating on the 5 GHz band, then make sure it is using channels 36 - 48 if your TL-WR902AC is an "EU" version or channels 36 - 48 or 149 - 165 if your TL-WR902AC is a "US" version.

 

Other 5 GHz channels are not supported by the TL-WR902AC.

  1  
  1  
#2
Options

Information

Helpful: 0

Views: 320

Replies: 1

Related Articles