Deco Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco Configuration
Deco Configuration
2024-03-01 15:49:16 - last edited 2024-03-04 11:31:16
Model: Deco M5   Deco M4  
Hardware Version: V3
Firmware Version: 1.3.14

Which of these 2 scenario works for deco system?

Do all other additional deco need to be in range of the main deco or can it connect to other additional deco unit like shown on diagram below?

 

note: all this is connected through wireless. the only cable attached are into the main deco

i am using deco m5 v3 US firmware 1.3.14
and deco m4R v2 US firmware 1.6.1

 

Thanks

  0      
  0      
#1
Options
1 Accepted Solution
Re:Deco Configuration-Solution
2024-03-01 16:29:35 - last edited 2024-03-04 11:31:16
Recommended Solution
  0  
  0  
#4
Options
3 Reply
Re:Deco Configuration
2024-03-01 15:49:54 - last edited 2024-03-01 15:51:30

this is the 2nd scenario  @Vraze 

  0  
  0  
#2
Options
Re:Deco Configuration
2024-03-01 16:08:39

  @Vraze the Deco network doesn't need every single unit to connect to the main unit. Ideally they should all be spread out evenly to cover the various corners of your property. The farthest unit might not even be able to pick up a fringe signal from your main unit but as long as there is an unbroken chain back to the main node they should all work.

XE75 V1.0 3-pack / Wired backhaul / Router mode / UK
  0  
  0  
#3
Options
Re:Deco Configuration-Solution
2024-03-01 16:29:35 - last edited 2024-03-04 11:31:16
Recommended Solution
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 432

Replies: 3

Related Articles