Home Network Community > All Threads > Changing configure for Deco X50
< All Threads

Changing configure for Deco X50

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Changing configure for Deco X50

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Changing configure for Deco X50
Changing configure for Deco X50
2024-03-26 15:57:15
Tags: #Network Connectivity
Model: Deco X50  
Hardware Version: V1
Firmware Version:

Dear Tp-link,

I have an existing wifi system with Deco X50 (3 packs). Currently, I configed the Main X50 with Dynamic IP (not PPPOE). Now the IPS provider tells me that they can convert the modem via Bridge mode, and I will change configuration for X50. So how do I reconfigure via Deco app? Or I must to hardware reset main pack and start absolute new?

Tkanks!

  0      
 
  0      
 
#1
Options
1 Reply
Re:Changing configure for Deco X50
2024-03-27 03:16:33

  @Huubita 

Hi, welcome to the community.

You could go to Deco APP>More>Internet connection>ipv4>Dynamic IP, and change it to PPPOE. In this way, there is no need to reset and set up Deco X50 from scratches.

Best regards.

Check What's Currently Going on With Deco Deco Early Access Firmware Open for Test! Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience! Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 547

Replies: 1

Tags

Network Connectivity
Related Articles
X50 config issue
95 1
Configure Deco X50 Without Internet Connection
332 0
How to Install and Configure the Deco X50-Outdoor
907 0
EE Sim Configuration X50-5G
1048 0
Intranet problem with Deco x50 mesh configuration
668 0
Known device alerts config broken - Deco X50 FW 1.5.5
367 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.