Home Network Community > All Threads > Main disconnects when adding a new DecoXE75
< All Threads

Main disconnects when adding a new DecoXE75

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Main disconnects when adding a new DecoXE75

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Main disconnects when adding a new DecoXE75
Main disconnects when adding a new DecoXE75
2024-05-30 21:59:50 - last edited 2024-05-30 22:11:49
Model: Deco XE75  
Hardware Version:
Firmware Version:

When Adding a new unit the Deco main reboots.

The new unit stays in flashing blue sequence.

 

if I'm fast I can add the new unit, but then the new unit either stays in permanent blue or flashing red (since the main unit eventually reboots).

 

If the unit stays in flashing red, performing the hard reset procedure does not execute. Stays in flashing red forever, even if I power cycle the unit.

 

feels like I have 3 units bricked already. 
 

help please. I'm losing faith in this product.

  0      
 
  0      
 
#1
Options
2 Reply
Re:Main disconnects when adding a new DecoXE75
2024-05-30 22:14:16

 Looks like this is the normal sequence.

flashing blue -> solid blue -> flashing red -> solid red -> green

 

 

The time spent writing the post was enough to see the entire cycle. I was stopping the procedure (disconnecting the unit) at the flashing red. 
 

This sequence is not obvious in the app....

  1  
  1  
#2
Options
Re:Main disconnects when adding a new DecoXE75
2024-05-31 08:37:37

  @A2day 

Hi, welcome to the community.

The expected LED sequence should be:

Solid yellow -> flashing yellow -> flashing blue -> solid blue -> solid green

In the normal setup process, a red LED is not supposed to be seen.

 

For Deco XE75, the units in the same kit are pre-configured: When the main unit is set up successfully, the satellite units can join into the mesh automatically.

So the LED sequence would be a little bit different:

Solid yellow -> flashing yellow -> flashing blue ----> Solid green.

 

Are you still having issue about the configuration?

If yes, our hotline/ live chat support would love to provide further assistance.

Thank you very much and best regards.

 

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 225

Replies: 2

Related Articles
Adding new x20
59 0
Problem adding AX20 to AX72 (Main) using EasyMesh
783 0
adding more than one 'bridge' to the main Deco control unit
1331 0
Deco XE75 Regular Disconnects after Automatic Firmware Update
401 2
Adding a "cheap" deco to extend my network
548 0
DECO XE75 - when I plug in a cable it disconnects from Wifi
666 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.