@AydAl 

Hi,

When you use the EasyMesh functionality to create a mesh network with 3 routers, those 3 routers will automatically share the same 2.4GHz channel.

It may cause congestion and crowding on the 2.4GHz.

You mentioned if they work in AP mode it would be better. Did you set all three units into AP mode?

For your case, it is recommended to use AP mode, so that you can manually set different 2.4G channel, like 1, 6 and 11.

This will distribute the 2.4GHz devices across different channels, reduce the interference and congestion between the channels, and help improve the performance.

  @AydAl 

Hi,

If the Mesh network is needed, please also check whether changing the channel width can help.

Please change the channel width to 20MHz and then restart all your AX53 devices.

If the unstable or slow speed issue still exists after you change the channel width, please reply to the post and provide the following information. We would like to escalate your case to our senior engineers for further analysis and help.

1. When did you purchase the AX53 routers?

2. Where do you use the AX53 routers? Is it in a home environment, or in the factory, or somewhere else?

3. Please provide us your network topology. It would be nice that you can draw a picture of it.