Deco x10 setup on KCOM

Deco x10 setup on KCOM

Deco x10 setup on KCOM
Deco x10 setup on KCOM
2024-08-30 01:44:37
Model: Deco X10  
Hardware Version:
Firmware Version:

Hi, 

Ive just purchased the X10 as quite a few areas in my house with poor signal, when I've tried to set up by connecting it to the modem I'm having no luck. Connected it to the router provided by KCOM and it works but I'm only getting 50mbps where should be 300. 
Mice rang KCOM and they've said could be because of the static IP which they've given me with my username and password but I have no idea where that goes. Tried setting up with static op on the set up and it asks for subnet mask, gateway, DNS honestly don't know where I'm supposed to find any of it.

 

any help would be appreciated 

  0      
  0      
#1
Options
1 Reply
Re:Deco x10 setup on KCOM
2024-09-02 01:19:33

  @Mcsanks Hi, Thanks for the feedback.

Since there is already an ISP-provided router, Did you also set the username and password(or PPPOE) for the internet connection on the KCOM router?

It is suggested to set Deco X10 into Access point mode:

How to set up Deco to work in Access Point mode

Thank you and best regards.

 

 

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 185

Replies: 1

Related Articles