Home

Forums

Stories

Knowledge Base

Home Network Community > All Threads > TP-Link LS1008G Switch won't go past 100Mpbs

< All Threads

TP-Link LS1008G Switch won't go past 100Mpbs

bigbadwolffe

2024-09-20 12:45:25 - last edited 2024-09-24 01:31:14

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-09-20

TP-Link LS1008G Switch won't go past 100Mpbs

2024-09-20 12:45:25 - last edited 2024-09-24 01:31:14

Tags:

Model: LS1008G

Hardware Version: V3

Firmware Version: N/A

Hi,

Got this LS10008G switch 10/100/1000Mpbs for quite some while, but the speed won't go over 100Mpbs.

The configuration is the following: Orange router (1800Mpbs plan) > (30m CAT6) > LS1008G > PC (motherboard 10/100/1000Mpbs), however, the speed will peak at 100Mpbs.

Is there anything that has to be done in particular for this switch to get closer to that 1000Mpbs?

Thank you!

1 Accepted Solution

terziyski

LV7

2024-09-21 00:24:34 - last edited 2024-09-24 01:31:14

Posts: 7141

Helpful: 5351

Solutions: 1220

Stories: 7

Registered: 2013-10-12

Re:TP-Link LS1008G Switch won't go past 100Mpbs-Solution

2024-09-21 00:24:34 - last edited 2024-09-24 01:31:14

@bigbadwolffe

Usually this is cause by the bad cabling. CAT 5e would suffice too.

You can check that by using a shorter factory made quality cable between the orange router and the LS1008G just for the test.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Recommended Solution

1 Reply

terziyski

LV7

2024-09-21 00:24:34 - last edited 2024-09-24 01:31:14

Posts: 7141

Helpful: 5351

Solutions: 1220

Stories: 7

Registered: 2013-10-12

Re:TP-Link LS1008G Switch won't go past 100Mpbs-Solution

2024-09-21 00:24:34 - last edited 2024-09-24 01:31:14

@bigbadwolffe

Usually this is cause by the bad cabling. CAT 5e would suffice too.

You can check that by using a shorter factory made quality cable between the orange router and the LS1008G just for the test.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Information

Helpful: 0

Replies: 1

TP-Link LS1008G Switch won't go past 100Mpbs

TP-Link LS1008G Switch won't go past 100Mpbs

Information

Voters 0

Tags