Archer AX73 Ethernet Status - LAN2 seems to be capped / LAN4 is disabled
Hi, my Archer AX73, I detected this problems after several years of using.
LAN2 speed seems to be capped and LAN4 is disabled.
In my opinion, it's likely a hardware issue or Can I just configure some settings to solve it ?
Thank you for advices.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
In that case it's probably a HW issue and you probably should contact your local support for help.
- Copy Link
- Report Inappropriate Content
If you don't have anything plugged in LAN 4 its status would be like in your screenshot.
In LAN 2 you probably have plugged a device which can't sync on 1000mbps bandwidth.
Plug that device in LAN 4 port and check the negotiated speed. If it's the same change the ethernet cable and test again.
- Copy Link
- Report Inappropriate Content
@terziyski I did it, unfortunately, for LAN4, anything is not function
For LAN2, I switched LAN1 which is 1000Mbps, at LAN2 its speed decreased to 100Mbps.
Therefore, I think it apparently is the issue of hardware.
- Copy Link
- Report Inappropriate Content
In that case it's probably a HW issue and you probably should contact your local support for help.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 100
Replies: 3
Voters 0
No one has voted for it yet.