WA901ND V3, can't connect Bridge to Bridge
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WA901ND V3, can't connect Bridge to Bridge
Region : Sweden
Model : TL-WA901ND
Hardware Version : V3
Firmware Version :
ISP :
I wan't use two pcs of TL-WA901ND to "bridge" them together in long distance with external TP-link antennas.
On the v3, it's impossible to run "Bridge to AP" on both at the same time and run "Survey".Firmware 3.13.31
On the TL-WA901NDv2 it was possible to run the Bridge mode on both of them and set MAC, SSID etc.
The problem with v2 is that it works great with Windows XP, Win 7 but it crasches after a couple of seconds with Windows 8 64 bit.
Any procedure or other to get this running?
Model : TL-WA901ND
Hardware Version : V3
Firmware Version :
ISP :
I wan't use two pcs of TL-WA901ND to "bridge" them together in long distance with external TP-link antennas.
On the v3, it's impossible to run "Bridge to AP" on both at the same time and run "Survey".Firmware 3.13.31
On the TL-WA901NDv2 it was possible to run the Bridge mode on both of them and set MAC, SSID etc.
The problem with v2 is that it works great with Windows XP, Win 7 but it crasches after a couple of seconds with Windows 8 64 bit.
Any procedure or other to get this running?