Deco BE65 firmware 1.1.2 - backhaul only using Ethernet
I have three Deco BE65s, all version 2 hardware. Since updating firmware to 1.1.2 the backhaul has changed to Ethernet only, as opposed to Ethernet + 5Ghz + 6Ghz.
Any idea why, or how to get the multipoint backhaul back?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, Thank you very much for the feedback, and nice to see you again.
based on the previous feedback, the combined backhaul sometimes caused a network loop on certain occasions. So 1.1.2 version here has temporarily disabled the WiFi Backhaul when the Ethernet Backhaul is active. Later It is planned to add a toggle for users to decide whether to disable the WiFi Backhaul or not.
It is also suggested to test the on-going 1.1.4 firmware here: Deco BE65_V2_1.1.4 Further Optimized Client Connection Status and Network Stability
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
Hi, Thank you very much for the feedback, and nice to see you again.
based on the previous feedback, the combined backhaul sometimes caused a network loop on certain occasions. So 1.1.2 version here has temporarily disabled the WiFi Backhaul when the Ethernet Backhaul is active. Later It is planned to add a toggle for users to decide whether to disable the WiFi Backhaul or not.
It is also suggested to test the on-going 1.1.4 firmware here: Deco BE65_V2_1.1.4 Further Optimized Client Connection Status and Network Stability
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 212
Replies: 1
Voters 0
No one has voted for it yet.