Problems with TL-WPA4220T KIT AV500
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Problems with TL-WPA4220T KIT AV500
Region : UnitedKingdom
Model : TL-WPA4220
Hardware Version : V1
Firmware Version :
ISP :
Morning all;
recently purchased a TL-WPA4220T KIT AV500 from Amazon. I have a Netgear D6200 dual band WiFi modem / router which works a treat.
Setting up the 4220T kit was a nightmare, but eventually did it using logic rather than the instruction sheet! 5 hours later and everything is working well and I now get WiFi all over the house.
However, when I look in the Powerline Utility and see the two 4220 bits of kit, one device shows a rate of 263Mps, whilst the other shows a rate of just 11Mbps, and nothing that I've tried can change this. Is this something I should be concerned about? If so, can someone point me in the right direction to correct this?
Thanks in advance.
Model : TL-WPA4220
Hardware Version : V1
Firmware Version :
ISP :
Morning all;
recently purchased a TL-WPA4220T KIT AV500 from Amazon. I have a Netgear D6200 dual band WiFi modem / router which works a treat.
Setting up the 4220T kit was a nightmare, but eventually did it using logic rather than the instruction sheet! 5 hours later and everything is working well and I now get WiFi all over the house.
However, when I look in the Powerline Utility and see the two 4220 bits of kit, one device shows a rate of 263Mps, whilst the other shows a rate of just 11Mbps, and nothing that I've tried can change this. Is this something I should be concerned about? If so, can someone point me in the right direction to correct this?
Thanks in advance.
