TD-W8980 Router. Unable to use SNMP
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TD-W8980 Router. Unable to use SNMP
Region : UnitedKingdom
Model : TD-W8980
Hardware Version : V1
Firmware Version : 0.6.0 1.7 v000e.0 Build 140701 Rel.41204n
ISP : Plusnet
Although I have enabled the SNMP option on the router I cannot get it to respond to a ping or an Interrogation from FrameFlow.
The IP address is in the same subnet as my PC e.g. 192.168.1.4 for the SNMP agent and 109.168.1.9 for the PC.
If I look at the ARP table in the router it does not show the Agents IP address ( 192.168.1.4).
Any one else experienced similar difficulties?
Any advice or suggestion would be greatly appreciated.
Kind regards
Terry
Model : TD-W8980
Hardware Version : V1
Firmware Version : 0.6.0 1.7 v000e.0 Build 140701 Rel.41204n
ISP : Plusnet
Although I have enabled the SNMP option on the router I cannot get it to respond to a ping or an Interrogation from FrameFlow.
The IP address is in the same subnet as my PC e.g. 192.168.1.4 for the SNMP agent and 109.168.1.9 for the PC.
If I look at the ARP table in the router it does not show the Agents IP address ( 192.168.1.4).
Any one else experienced similar difficulties?
Any advice or suggestion would be greatly appreciated.
Kind regards
Terry
