Home Network Community > All Threads > D5 and multiple static IPs
< All Threads

D5 and multiple static IPs

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

D5 and multiple static IPs

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
D5 and multiple static IPs
D5 and multiple static IPs
2014-12-07 15:55:49
Region : Argentina

Model : TD-W8968

Hardware Version : V3

Firmware Version :

ISP :

Hi..

I have a block of static IPs which I am trying to get working with my Archer D5.

I have a static IP of x.y.z.13 which is supplied by my internet provider and another block of x.y.z.40 - 47 (also supplied by my internet provider).

The modem has no problem with the x.y.z.13 (pppoE), but I cannot use my other block of IPs..

There doesn't seem to be any way to disable NAT on this thing or perform any one to one NAT or something similar... the telnet interface borders on useless.

Is anyone able to help me with this?

Thanks.
  0      
 
  0      
 
#1
Options
6 Reply
Re:D5 and multiple static IPs
2014-12-08 15:18:07
I don't think D5 has multi-NAT function.
  0  
  0  
#2
Options
Re:D5 and multiple static IPs
2014-12-09 04:33:02
What adsl modem were you using prior to using the Archer D5?
What ATM configuration and WAN service were you using to route your block of IPs with your original adsl modem? vpi? vci? PPPoE? PPPoA? IPoA? 1483Bridge?
  0  
  0  
#3
Options
Re:D5 and multiple static IPs
2014-12-09 06:18:13
Hi ...

My previous modem was the TP-Link TD-8840... no special setup, just PPPoA.

I was able to telnet into this device and turn off the NAT through that .. all very simple .. then I had my server, on the LAN side, do all my routing for me.

Thanks.
  0  
  0  
#4
Options
Re:D5 and multiple static IPs
2014-12-09 13:04:04
If your ISP uses PPPoA then you can also use IPoA if your ISP supports it. You can disable NAT on the WAN Settings.

  0  
  0  
#5
Options
Re:D5 and multiple static IPs
2014-12-12 11:58:58
Hi, yeah, I don't think I have that option :-(.
  0  
  0  
#6
Options
Re:D5 and multiple static IPs
2014-12-12 22:25:21
The screenshot above is for the Model : TD-W8968
If you have a TD-W8968 as you stated in your post then you should have this option with the latest firmware.
Type in your static IP address and configure your LAN with the IP range allocated by your ISP. Uncheck NAT.
  0  
  0  
#7
Options

Information

Helpful: 0

Views: 693

Replies: 6

Related Articles
Archer D5 with static IP from ISP
560 0
TD-W9970, BT and static IPs
597 0
Archer D2 Multiple WAN IPs
439 0
IPs get resetted. Any teick to make them static?
333 0
Archer VR2600 with BT Static Public IPs
442 0
Archer C5400 static IPs in access point mode?
262 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.