PA4030 does not go into power-saving mode!

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

PA4030 does not go into power-saving mode!

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
PA4030 does not go into power-saving mode!
PA4030 does not go into power-saving mode!
2016-01-24 03:31:11
Model : PA4030

Hardware Version : V1

Firmware Version : 500A-1.1.0.844-01_403011_140126

ISP :

Hi,
I just installed two PA4030 on a network till now composed of two PA6010.
After the installation I checked that the PA4030s did not go into power-saving state. So I run the SW you provide here
http://forum.tp-link.com/showthread.php?3666-how-to-solve-some-powerline-adapters-can%92t-be-waked-up-by-some-network-adapters and I realized that the Standby Mode was OFF in both the PA4030, so I set it ON, but the devices do still not go into standby!
The firmware is the latest one available: 500A-1.1.0.844-01_403011_140126.

PA6010s on the same line/network go correctly in standby.

What's the matter?
  0      
  0      
#1
Options
1 Reply
Re:PA4030 does not go into power-saving mode!
2016-02-03 21:36:59
Problem still persists after an adapter reset!
Any idea from TP-LINK staff?
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 576

Replies: 1

Related Articles