Connecting Archer C2 router to Virgin Media Superhub
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Connecting Archer C2 router to Virgin Media Superhub
Model :
Hardware Version :
Firmware Version :
ISP :
I have just purchased a TP-Link Archer C2 router to connect to my Virgin Media Superhub.
I have set the Superhub to modem mode and if I then connect one computer directly to the first port on the hub, I can connect to the Internet. However, when via the the C2 router, I cant connect.
I tried manual setup and entered my WAN IP, I believe the VM Subnet Mask is 255.255.254.0, but I cant find the Default Gateway anywhere. I have found the DNS servers: 194.168.4.100 and 194.168.8.100.
I have asked on VM forum for the DG but I wonder if I have not understood the setup on the C2.
Any help would be appreciated.
Thanks
Hardware Version :
Firmware Version :
ISP :
I have just purchased a TP-Link Archer C2 router to connect to my Virgin Media Superhub.
I have set the Superhub to modem mode and if I then connect one computer directly to the first port on the hub, I can connect to the Internet. However, when via the the C2 router, I cant connect.
I tried manual setup and entered my WAN IP, I believe the VM Subnet Mask is 255.255.254.0, but I cant find the Default Gateway anywhere. I have found the DNS servers: 194.168.4.100 and 194.168.8.100.
I have asked on VM forum for the DG but I wonder if I have not understood the setup on the C2.
Any help would be appreciated.
Thanks