I had big problem when I configure AP's to work with oc200 and TL-R605 (using manual IP, mask, gateway and DNS addresses). In this configuration I used tp-link switches but not dedicated for Omada. Wi

Just updated to the latest OC200 a few minutes ago. now it is stuck in this infinite loop of trying to adopt/ provision the R605 router. anyone else run into this ?

On-going Pre-release Firmware Trial for Omada Controllers ER7212PC V1 (Built-in Omada SDN Controller 6.0) Pre-release (Released on 22nd Jan, 2026) Closed Pre-release Firmware Trial for Omada Controlle