@R1D2 ive tried all your steps as described in post 15 both aps are eap225 outdoor v1 firmware is 1.20 - does this have to be updated? both were configured and adopted connected to the network using...

@R1D2 ok 1 more dumb question. am i best to reset the Omada 200 controller and both the eap225 units i have and start from scratch using gthe PC based controller software. Also the EAP225's that i...

the controller and eap's were set using the ipad app. i have downloaded the controller software but it seems to want to go through the entire set up process again????

can i do this from the ipad based app or does it have to be done using the PC version. when i unplug the 2nd eap it seems to remain "disconnected"

@forrest i followed the 2nd way described below and got as far as step 4. cant figure out how to "configure the uplink to isolated" a little help here please!!!