Alexandre.LV6Online
Following: 0Followers: 9
Forums/ Deco
2024-05-16 11:41:13
Re:Guide on mesh units
NetStream wrote @Alexandre. Does keeping an m5 in each room sound good or is it redundant @NetStream If each Satellite M5 is Ethernet connected, as you said initially, it would be good to have M5 in...
0HELPFULS
Forums/ Deco
2024-05-15 19:52:52
Re:1 node will not connect.
@TOP1980 Usually X-series Deco from same set should just find each other, but in your case manually adding that third Deco to Deco mesh will be required. The manual process: 1. Keep that Satellite...
2HELPFULS
Forums/ Deco
2024-05-15 19:31:22
Re:Help - Large house cat6 Ethernet - can I expand network via Ethernet?
@Tedrino As a first step, you will need to configure Deco mesh to run in Access Point mode: https://community.tp-link.com/en/home/kb/detail/334 After that, you can connect Satellite Deco XE75 Pro...
1HELPFULS
Forums/ Deco
2024-05-15 11:35:14
Re:Guide on mesh units
NetStream wrote @Alexandre. In your above reply, you stated that I could place a unit in living room and in the common area in front of master and kids bedroom. In that case, won't there be frequent...
0HELPFULS
Forums/ Deco
2024-05-14 14:06:05
Re:Deco M9+ : slowly loses speed until reset (AP mode)
@Hansvdc Yes, that should be OK. Check Update Deco page - if all your M9 Plus are on this firmware and none left with firmware 1.2, in the future you can just use Update Deco to check for new...
0HELPFULS
Forums/ Deco
2024-05-14 11:47:46
Re:Deco M4R 100% CPU and no connectivity
@dzqz If ISP provided you with the router/gateway to which Main Deco is connected, you can switch Deco to Access Point mode. This will substantially offload Main Deco. See Switching a Deco to Access...
0HELPFULS
1128129130...