@Aserin Deco M9 firmware does not come with scheduled reboot feature yet, and you must have it on all Deco units in the Deco mesh to be able to configure it. If you would like, you could install M9...

@Skeeve_Stevens Yes, DHCP IP address reservation on router is the only way. In Access Point mode your Deco units are just regular networking devices as far as Archer router concerned, no different...

@Skeeve_Stevens You do configure static IP addresses for Deco X75s in Archer AXE75 router configuration settings. There, in Archer router, you will see Deco X75s as regular wired networking devices...

@Jeffg53 What you described could happen if switch(es) at your home network through which Deco units are connected do not support Deco Ethernet backhaul protocol. This could make Deco unstable. DLink...

@Hkphooey You will get the same WiFi speeds. This configuration change applies to Deco mesh, not to individual Deco units. After you follow steps from the document I shared your Deco mesh, all its...

@Hkphooey Have you got "Double NAT detected" error message on XBOX? In that case, the solution is to configure Deco mesh run in Access Point mode: How to set up Deco to work in Access Point mode