@Manuel78 This is beta code, so it is most likely an issue on TP-Link side. Their Support scans forum topics, but just in case please also post about this in the forum topic about M4 firmware:...

@Ufin If your Deco setup is as following: then I would recommend to configure Deco mesh to run in Access Point mode. That will make all Deco nodes use Ethernet for backhaul. See How to set up Deco to...

@Andy737 You can make everything work again, and together with Deco mesh, in two simple steps: 1. Put Virgin hub back to its original mode, which is router mode. Verify that devices connected by...

@Manuel78 With Deco mesh, Satellite Deco prefers to connect to Main Deco. It would only connect to another Satellite if signal from Main Deco is extremely weak or non-existent. Until recently, that...

@kpn8210 If ISP Support can see that you have TP-Link device connected to their ISP Router, with 100Mbps, that means your router can report devices connected to it and can report negotiated speed of...

@obag87 About the script. The script will ping well known web site. It will stay silent if ping is successful, but when ping fails it will start reporting failure with time stamp. When connection...