@Chayan_Paul You need to configure Deco mesh to run in Access Point mode. In that mode, all devices will be on the same 192.168.1.* subnet. Follow this document: How to set up Deco to work in Access...

@DMKKG You should connect Main Deco to LAN port of your router.

Alexandre. wrote @ChrisH64 You'll have to find desktop or laptop with gigabit Ethernet card, wire it to the second port of Main Deco X60 and run speed test on that desktop/laptop. That speed test...

@ChrisH64 With the same setup as previously, check that your mobile device you use to run speed tests has good WiFi connection to Main Deco X60. WiFi connection speed reported on that device...

@ChrisH64 You should expect 500Mbps with properly configured Deco mesh consisting of X60s, which means something is not right. I'll give you basic troubleshooting steps to narrow where the problem...

@Yibar If you plan to use Ethernet backhaul, X60 speed will be in the WiFi 6 range, and with gigabit Internet connection you should expect X60 WiFi speeds to be in the range of 800Mbps-1Gbps. You...