@CmV I have Hitron cable router, too, and when I added Deco mesh to it and disabled WiFi at Hitron, I find that router quite satisfactory. My Hitron works fine as cable router, especially after few...

@rmason I think I may be able to explain what is going on and offer configuration settings you could try, to address the issue. Also, I can provide an alternative ironclad solution (but you'll have...

@Brewster You should be able to share printer in Deco Router mode. It is, indeed, common household requirement. Conceptually, Deco mesh in Router mode is single WiFi router with very strong WiFi...

@Brewster What you need to do is configure Deco mesh to run in Access Point mode. This should fix WiFi printer access. I also expect your Bell router will again show your devices with familiar...

@Angry_muppet I can give you suggestion how to fix the issue. Assuming you still have Fritz!box and it runs as a router/gateway (configuration it should have come with), what you need to do is...

@RobPettengill If you like Deco mesh WiFi coverage, and have Apple Airport router, you can run Deco mesh in Access Point mode. It will be: Docsys modem<--->Apple Airport router<--->Main Deco X20 See...