Hi @Fae, After firmware upgrade cloud indicator turn off then after a while it's blink on and off also for eth1 and eth2. No I'm not trying to replace software controller. I'm trying this to...

Hi @John1234, On your second point. So eth1 connect into router and eth2 connect to my computer directly? My experience on your third point. I can see that after I enable connect cloud from software...

Hi @Somnus, thanks for replying. Have you checked if the all the cable connections from dlink 612 to your OC200 are good? You can simplify your topology, connecting OC200 directly to dlink612 to...

@Somnus My network topology is like this. Internet -> dlink 612 (ip 192.168.0.1) -> Omada Software Controller (192.168.0.3) -> dlink 615 (ip 192.168.100.1) -> Omada hardware controller (didnt get IP...

@Somnus . I have tried this one. with the latest firmware OC200(UN)_V1_1.7.1 Build 20201016 . But my oc200 still didn't get IP address from dlink router. any other solution? I have also tried this...

I have bought one oc200. I have also omada sofware controller on my PC and have installed it and used it. in my omada software controller i have set ip address 192.168.1.3 First i have tried another...