In Omada cloud under devices in my routers network tab I have 4 networks listed which are LAN,Guest, Security, and IoT. None of which show any clients connected to the networks. I know these networks...

1. I recreated all the ACL policies I originally deleted and the policies still didn't work. 2. I then pulled my v1 er605 off the shelf and put it in place of the v2 and the acl rules worked. 3....

@Clive_A 192.168.0.XXX is the Wireguard 10.100.100.XXX is the LAN I had created ACL rules that didn't work and before the start of this thread were deleted from the Switch and Gateway to save myself...

@Clive_A I have tried ACL's at every level Gateway, Switch, and EAP. At this point in time it looks to be only wired clients connected to the switch that I am able to access when connected externally...

Has anyone been able to properly setup any ACL's for their omada wireguard vpn config's so it will not route and allow access to all the vlans in your networks? Documentation is close to meh at best...

@Virgo My mistake was following this walkthrough (https://www.tp-link.com/us/support/faq/3559/) when trying to setup the wireguard vpn. I created a new LAN/VLAN interface for wireguard during the...