NapsterbaterLV2Offline
Following: 0Followers: 2
Forums/ Wireless
Yesterday
Re:EAP7xx v1.4.0 Fully Adapted to Omada 6.1 Pre-release Firmware (Update on 11th Dec, 2025)
@Vincent-TP so the 773 is just going to continue to be ignored? It got removed from the previous beta post, and you continue to ignore questions about it., Also the 772-Outdoor Update is also...
0HELPFULS
Forums/ Wireless
Yesterday
Re:EAP773 | EAP783 v1.1.1 Pre-release Firmware (Update on 4th Nov, 2025)
@AP-adrift Maybe you'll get a response, they've been absolutely silent every time I've asked.
0HELPFULS
Forums/ Wireless
Friday
Re:EAP773 | EAP783 v1.1.1 Pre-release Firmware (Update on 4th Nov, 2025)
@Napsterbater anything?
0HELPFULS
Forums/ Wireless
a week ago
Re:EAP650-Desktop, Mesh Uplink, ETH0 Can not be configured at ALL, Really?
@Vincent-TP 1. Except when using this device with a wireless up link.. it's essentially a useless port depending on the configuration of the network, such as if someone follows best practices and the...
0HELPFULS
Forums/ Wireless
a week ago
Re:EAP650-Desktop, Mesh Uplink, ETH0 Can not be configured at ALL, Really?
@Napsterbater Turns out as well, the EAP650-Desktop can not even "detect" clients on its ports and can not even show port status. The client I have on one of its ports shows as connected to the...
0HELPFULS
Forums/ Wireless
a week ago
Re:EAP650-Desktop, Mesh Uplink, ETH0 Can not be configured at ALL, Really?
@jra11500 Putting my Linux hat on, which these run. Once wirelessly meshed that wireless interface should be the only thing needing VLAN 1 at a minimum. I'm sure at this point it is unlikely for this...
0HELPFULS
123...