@Bpp I assume you have another wifi enabled router or modem/router that you are augmenting with the EAP225? If so, don't expect seamless roaming between the two, and you won't even be able to connect...

@Gjjb For the sake of $70 (newegg dot ca) for the ER605, you would get a richer Omada experience. Same for the SG2008P / SG2210P (not sure I'd fork out for the SG2210MP for your setup)... you'd get...

@SonicXtasy You should ensure that you have band steering enabled, set your 2.4G channels to 20Mhz and static configure them to use only Ch1,6,11, and you may want to intentially decrease the RF...

@Bpp RTFM? isolated would seem to indicate it has not received an IP during its initialization process. Check your wiring, or if you are trying to mesh, make sure your Omada Controller is connected...

@jilio It gets slightly worse...you won't be able to import your current OC300 config into the software controller either, assuming it has the same issue as the OC200's do on 5.7.6, but will instead...

@oschu I have tried exactly the same thing with no success. There seems to be a fundamental compatibility issue with OCxxx 5.7 backups and Linux based software controllers (and I've tried 5.6, 5.7,...