I have an OC300 controller with three sites connected via SD-WAN. Only one of them has a public IP address. Is it possible to set up NAT on site with public IP address so I can access a service on a...

@RaRu Thank you, it seems promising. I can buy some cheap LTE router, put it i to bridge mode and connect to Wan port of Er605, but using USB modem is a lot easier.

I haven't tried the 2.3.0 firmware yet, but I have a related question. Is it possible to use/setup SD-WAN only with a USB LTE modem connected? I know VPNs can't use USB, so I'm wondering if it's the...

@Vincent-TP Problem is that both V1 clients I have now don't see V2 uplink unit, only two original V1 uplinks.

I've noticed mention of new firmware in OC300 Global view -> firmware: EAP211-Bridge(EU) v2.0 Release Note 1.0.2 Build 20241209 Rel. 43851 Recommended Controller Software Version: Omada Controller...

I have 6 EAP211 units. 2 pairs (4 units) are hardware v1, 1 pair (2 units) are hardware v2. All 3 pairs works without any problem. Now I would like to make PtMP with two v1 units (one as uplink, one...