@jra11500 Thanks for sharing. First of all I'm in Access Point mode and no isolation can be set up in this mode and since Guest/IoT is not Meshed I would not be able to reach all my CAMs from the...

@terziyski Ohh - I now see that this issue has existed for more than three (3) years and apparently still mot solved: Guest Network on OneMesh nodes? I can understand that in case of classic WiFi...

@terziyski All routers are AX55 - only one Main Router and one Satellite in the EasyMesh config. Two access points with identical SSIDs in the "Wired Dual Access Point Mode". With current Firmware it...

@terziyski Thanks for the answer! Seamless Roaming: I think that this is also happening using the "Dual Access Point" architecture. I'm pretty sure my Phone and my Notebooks chooses the WiFi channel...

Hi, I have set up two AX55 as EasyMesh devices in Access Point Mode (with active Ethernet Backhaul) connected to my DMZ network and - until now - it works well. I have also two AX55 both in Access...

@Sunshine Well if that was the case - then I would certainly have found it :-) The ability to manually set the IP Address via WEB GUI disappears of as soon as the router is set into Satellite mode....