Forums/
Routers
2024-04-05 12:41:36
Quick question: Running ER8411 V1.0 with Firmware 1.2.1 and a OC300 V1.0 controller with Firmware 5.13.30.20. Can see IDS/IPS, but no DPI. Is the function not available to all? Thx & Br's Thomas
0HELPFULS
Forums/
Controllers
2024-02-14 14:59:59
@d0ugmac1 found a solution to my problem, perhaps valuable/useful for you, too. Pls. see my post just above yours named "Access Point Detection" Thomas
0HELPFULS
Forums/
Controllers
2024-02-14 14:51:20
Issue solved. Solution for my case was as follows: - configured the AP at the site of the controller (site 1) as stand-alone AP (assume this can also be done at a locally different site) - once done,...
0HELPFULS
Forums/
Controllers
2024-02-14 08:26:44
Dear All, not sure if the right forum, or better to be placed in the WiFi/AP section. Following constellation: 2 remote sites (site 1 and site 2) controlled by an OC300 on site 1 2 tp link routers -...
0HELPFULS