@Hoamboy Updated the OC200 firmware and now able to set the correct IP group addresses. Thank you.

Firmware is 2.7.7 build20221206 ref. 56808 Controller 5.7.6 Worked on an older firmware just not this version. I got it to save by using 192.168.0.1/16 I’ll give the beta go although I now have beta...

Hi, I am trying to set up an IP group however I get errors with the IP addresses adn I don't know why:

@Hank21 Ok. The problem is I now have messages each time I open the controller saying the firmware needs upgrading as the beta is a lower number than what was there before.

@Hank21 Hi, That beta firmware seems to have worked. I installed it then rebooted the garage EAP and the devices received their fixed IP addresses as hoped. Should I install this beta firmware onto...

@Philbert hi, thanks for the reply. The Eap has each of the physical LAN ports set to the IOT 192.168.10.x VLAN in tha advanced config and so really there should be no way for that device to get a...