Hi @David-TP, Thank you very much for the quick response and helpful information! I actually have no trouble obtaining a public IP from my ISP using an older 4G router set to bridge mode, so I was...

Hello everyone, I’m thinking of getting the TP-Link Archer NX200 and need to confirm if it supports bridge mode or IP passthrough. My goal is to pass the public IP to a second router I have in my...

@d0ugmac1, After doing some tests I see that everything is working as I wanted. Thanks for your help. Regards.

@d0ugmac1,thanks. I understood the logic of the settings you sent. They are already implemented, later I'll tell you if it worked! Regrads.

@d0ugmac1, thanks in advance for your help. It becomes a little difficult for me to follow these steps because my menus are different. I don't use Cloud Controller Management to configure the ER605.

@d0ugmac1, yes I have my setup as you exemplified. My "usb modem" connection is only active when there is a failure in the main "wan" connection. As for this, everything is fine and working. But when...