I am using an IPv6 only network as my secondary backup WAN which provides IPv4 access through 464XLAT. Initially I used to have the ISP provided CPE in front of my ER605. But later removed it due to...

I have scheduled my wifi to turn off at 2:00am and turn back on at 7:00am daily. The problem is I don't need the 2.4GHz and keep it disabled whole day, only the 5GHz wifi is kept enabled. But in the...

Need IPv6 passthrough support in Archer MR600 so that my downstream ER605 can delegate prefix to the connected devices.

@paderijk mine is er605 v2 running in standalone mode with 2.2.0 firmware.

@vnan1829 yes ipv6 is working perfectly so far. I have two ISPs in load balancing setup. Getting ipv6 from both ISPs. All my ipv6 enabled LAN clients are also accessing ipv6 sites nicely. However,...

@lezz it's a basic allow and block rule, nothing extraordinary