Hi @Lobo_E, did you follow my automation instructions above? if so then point 6 in automation 2. "Alarm" Automation is the step which creates the 20 second delay. However, I have included a...

Hi @Makarov, I expect that creating loops has been deliberately blocked by the Tapo developers. There is a very good reason for this as if you create a loop without any delays then it would run at...

Hi @Pedr057, Effective time is only to restrict an automation to be triggered between certain times, I think you can leave it set to "Always" for this case. You can add triggers in the "When" to make...

Hi @Makarov, The Tapo automation does not allow loops to be programmed. However, one way to do this is to create an automation which triggers at any of the following times... midnight, 1:07am,...

Hi @ShubhamDwivedi, I don't have that specific model camera, however I believe most cameras have separate settings for detection vs notifications. Therefore you should leave motion and person...

Hi @MatsNits, The tapo automations support your described scenario and is actually how I have my lights set. I have an automation which turns on my hallway light when a person is detected by my...