Forums/
Routers
2024-09-20 18:12:58
@Clive_A Instead of using 0.0.0.0/0 as the allowed IP, which routes all the traffic to the peer, start with the subnet you expect to access to the peer. And, WG int with /32. See if that works. Thank...
1HELPFULS
Forums/
Routers
2024-09-20 06:19:49
Clive_A wrote The prerequisite is that routing all the traffic remotely(which you don't care about) depends on your tunnel connectivity. When the tunnel is not properly set up, the network will be...
0HELPFULS
Forums/
Routers
2024-09-20 02:01:34
@Clive_A thank for the response. I'm not looking to be spoon-fed, but also can't totally wrap my head around where I went wrong. I don't mind all remote traffic going through the local gateway, I see...
0HELPFULS
Forums/
Routers
2024-09-19 18:16:56
Two different office locations, both behaving the same. Followed this guide: https://community.tp-link.com/en/business/forum/topic/610198 Behavior: Previously, both Office A and B were on...
0HELPFULS