@whereisaaron on second glance, It sure looks like ports 1 and 3 are pre-configured as WAN ports, just like you suggested.

whereisaaron wrote @RisingMonk try moving to port say 5. I can't remember exactly which two ports started off as WAN, it could have been first 2.5G and first 1G, so thus ports 1 and 3. You might be...

whereisaaron wrote @RisingMonk I found the ER7412-M2 troublesome too. (1) Mine wouldn't work until I hard-reset it and update the firmware, it shipped with firmware too old for current Controllers...

@MR.S MR.S wrote @RisingMonk Omada routers have a default ip of 192.168.0.1, log on to the router and change to the ip address that is on the controller's network. the router's lan interface cannot...

I am trying to set up a newly purchased gateway (ER7412-M2) but I cannot access or “find” it. An on-site technician connected it to a switch, and I can see that the switch port is up. I can also see...

@Xariyx Xariyx wrote Also - why i cannot remove PVID from a port? I've got a workaround by creating "empty" vlan 1500 that i could block with ACLs or something, but i don't think that's an answer. I...