@Artur.Aragao Hi there, thanks for taking the time to share your thoughts on the TP-Link community—your feedback and ideas are truly valued. At this point, we can’t confirm whether this enhancement...

@Andres_Ramirez Thank you for your post. The issue is unlikely to be caused by the port—after upgrading the firmware, the original port can still be used to add devices without any problems....

@mrmanmsk What I’m listing here are only possible causes, so even after you make the adjustments the issue may not be resolved. The key is to mirror-capture traffic and compare the difference between...

@GaRv3 Thank you so much for taking the time to post the issue on the TP-Link community! To better assist you, I've created a support ticket via your registered email address and escalated it to our...

@CableWhisperer By default, on Omada all VLANs can reach each other and every VLAN can reach the WAN. Your current configuration is basically fine—go ahead and apply it, then double-check that each...

@flrwrzl Please first disable “Block Ping from WAN” in the location shown, then reboot the router. Additionally, temporarily place the NAS in the DMZ and see if the issue persists. If you have...