Jorge87 wrote Are there any known plans for adding Acceptable Frame Types = UNtagged Only to TP-Link switches? Inside a VLAN network there is no untagged traffic. All frames are always tagged. It's...

Jorge87 wrote Does anybody know how can I configure the switch to make a port to accept only untagged traffic, so a rogue device cannot spoof the VLAN? Yes. Assign each »Access Port« to only one...

@unmesh, my PoE injector included with EAP225 V3 negotiates 1,000 Mbps FD with my switch. Check your cable again. Is it shielded? As for iperf performance, see my post #5 in this thread for a...

SimonC. wrote BTW, I had some issues making the mesh function to work out of the box. I followed the instruction to "adopt" AP wirelessly but it fails all the times. I finally found that the...

@mduchaine, TP-Link support did made a statement here: https://community.tp-link.com/en/business/forum/topic/151455?replyId=430604 The »Business WiFi« forum is the correct place for discussions about...

Hello JSchnee21, Even with all of this connected, I generally see Wifi speed tests on my phone or laptop in the 300-500 Mbit/sec range (depending on how far I am away from a particular AP). Try...