@MarkMeij, did you set up and enable the EAP's SSID by logging into the web UI the first time or if using the Omada controller did you define a SSID? If so, do you use non-standard characters in the...

@lester, yes. that's the chicken-egg problem. Two solutions: Use DHCP to assign the EAP an IP address. Adopt the EAP until it goes into »Provisioning« state. Wait until it becomes »Disconnected«. Now...

@German93, could be either a channel problem (CPEs support only outdoor channels) or a distance problem (too short). You should be able to connect with the client directly to the public AP over a...

@MarioT, you can use the MAC filter setting to restrict connections from the cams to the CPE. Find it in the »Wireless« menu:

@lester, what's the IP of your network?

lester wrote why it always disconnect and failed to adopt my eap110... Are you using a mgmt VLAN (setting »Management VLAN« in Omada controller)? If not: did you hard-reset the EAP to factory...