defrank wrote If I set the eap 225 with the same SSID: * I suppose this solution has a different IP-network (range). To have the same IP range I better can use the deco's in a tupperware case...

@yandoo91, it's v2.2.1. I run the firmware from https://www.tp-link.com/en/support/download/wbs510/v2/#Firmware. But note that test mode will be disabled from 2.2.0 on upwards IIRC, even on V1...

@unmesh, glad it works for you. Just for the record: no manageable switch (even not Cisco switches) have an »untagged VLAN«. They just have untagged traffic which – by default – gets assigned to a...

@lester, for a wireless link over a distance of 700 meters you would use a directional link, e.g. two Pharos CPEs in a PtP setup. You could also use Tenda devices if they offer similar PtP CPEs which...

@OmadaSMS, SDN stands for »Software Defined Networking«. See Wikipedia: https://en.wikipedia.org/wiki/Software-defined_networking

unmesh wrote In Method 2, could I run VLAN 1 untagged instead of tagged? That way, I could plug in a non-VLAN aware device into the Ethernet wall jack where the EAP connects for, say, debugging? A...