It's not complicated to set up the APs. First of all, if you use them in standalone mode, you don't need the EAP controller software. Just connect to the web UI built into the EAPs and setup the SSID...

I wouldn't investigate too much time into the WRT1200 setup as long as it isn't sure that it can handle VLANs and open source software can configure it. Usually, VLAN tags are just used inside a...

cayvman wrote Any suggestions regards routers that would do what we've been trying to do? Did a quick check on OpenWRT and one of their recommendations was for the netgear WNDR3700 a router I had but...

Does not sound good. Now I understand what you meant with "script": did you insert a switch config manually? Usually the default config includes anything supported by the chip. If there is no VLAN...

cayvman wrote Also, don't know why when I go to the ip address I've been getting the message that the site is not secure/safe. Is it because I haven't set up any firewall directions? Sorry, did...

Boris01 wrote Well, firstly I think you are in error when you express that the latest firmware for hardware V1.0 is 2.0.0, That firmware version is for V2.X hardware versions. This is nonsense. I use...