Rod-IT wrote Any device hardwired to the switch show stable conenctions and uptime according to the device, it's hostname and IP where available, but the VMs only show a MAC address, so i've manually...

@CHASER, high channel utilization means that there are many WiFi devices around, what is not unusual outdoors. BTW: you run the EAP with 20/40 MHz channel width. 40 MHz causes the EAP to acquire 8...

@Rod-IT, I'm not familiar with ESXi VMs, but did you try to search the web for »ESXi VM loses network connectivity«? Lots of results appear for this search term ... including seeing IPs from the...

@alpha-1, sorry, there is no image, I don't use RasPi as a platform for SDN Controller. Please see post #8 in this thread, there is a link to a docker image you can try. It's much like an image,...

@alpha-1, the recipe you posted is for installing the official TP-Link version which differs greatly in installation procedure from the community version. The community version is being installed...

@bp1000, you're welcome. You can try to set a lower RSSI limit in »Load Balance« settings to specify at which minimum signal levels clients should be allowed to connect to the EAP. For example I just...