Hello @GRL that's what I tried. Unfortunately OPNsense didn't got an IP on the WAN interface. Instead, i found out now, that the VLAN itself got the IP from the modem. WTF? cellar#show interface...

Dear community, recently I tried to configure VLAN's on both of my SX3008F switches with the Omada Software controller. I have following setup: Switch1 Port1: WAN Modem Switch1 Port2: Windows PC...

Hello Clive, I now deleted the LAG and unplugged one cable. I'm very disapointed in TP-Links Omada switche. What I understood so far: the way I configured LACP is correct. The settings for LACP are...

Hello @Clive_A . Yes, I tried the settings you posted a few days ago, but it got worse. There are two sfp+ 10Gbe Modules in each switch connected via 20 Meter FTTH fibre cables. Each cable alone is...

Hello @Clive_A Here is the output of the command with port 7 plugged in: Keller#show etherchannel 1 detail Group state = L2 Ports: 2 MaxPorts = 16 Protocol: LACP Ports in the group:...

Dear @Clive_A , I'm not able to upload a network diagramm here, so I will post the code for mermaidchart: graph TD subgraph Router Internet["🌐<br>Internet"] end subgraph "Switch 1 | Clients &...