@Clive_A sorry for my late reply. I was a bit busy last days. I unplugged port 7 because of the instability. Here is the output as you requested: switch1# show etherchannel 1 detail Group state = L2...

This is the config of switch 1: !SX3008F # vlan 1 name "System-VLAN" # vlan 254 # hostname "Wohnen" location "" contact-info "" serial_port baud_rate 38400 ip dns-address primary 192.168.0.254 # #...

@Clive_A Thanks for getting into this. I don't have a CLI output, I used the Omada Controller Software to configure it. Now I deactivated spanning tree and loopback detection and it even got worsier....

Dear community, maybe you can help find the problem here. I'm running out of ideas. I have two SX3008F and want them to be connected via LACP on Port 7 and Port 8 with 10GB fibre. I started...

Hello @TP-Link_Deco, the Deco is not connected to the VLAN. The VLAN is only for the modem and the router, no other device are connected to this VLAN. So this is not the problem here. VLAN is...

Hello @TP-Link_Deco Of course I can describe my environment... I have two Deco M4R, the master is connected with a cat6 cable to a Ethernet Layer3 Switch, the secondary M4R is connected via the mesh...