nbaliLV1Online
Following: 0Followers: 0
Forums/ Controllers
2021-04-27 15:55:05
Re:How to stop inter VLAN routing on TL-R605 using OC200 controller (solved)
@ScottB.ca I have the same issue. Inter vlan routing is blocked for wifi devices but not for wired devices. I have set ACL's at Gateway and EAP. I dont have tplink switch in between but use a Dlink...
0HELPFULS
Forums/ WiFi
2021-01-22 16:54:23
Re:EAP245 V3 slow speeds after running for few hours
@PBGBBB2020 Hi, When I was troubleshooting this issue last year, I replaced 3 EAP245's, same results with all three. So it's definitely not a faulty hardware issue. It could be a firmware issue but I...
0HELPFULS
Forums/ WiFi
2020-07-07 14:55:27
Re:EAP245 V3 slow speeds after running for few hours
@sgnb I am running it on a Windows desktop on a 1gig Lan. I don't think it's the controller. To the date I have same issue, I gave up troubleshooting and just accepted to leave it as it is. I have a...
0HELPFULS
Forums/ WiFi
2020-05-01 22:39:11
Re:EAP245 V3 slow speeds after running for few hours
@R1D2 First of all thank you for your help in troubleshooting this with me. I understand throughput/bandwidth depends upon the available airtime at any given point in time. It is possible my...
0HELPFULS
Forums/ WiFi
2020-04-30 23:57:49
Re:EAP245 V3 slow speeds after running for few hours
@R1D2 I did a survey 10 ft from the AP mounted on the side exterior wall. This AP is the worst among all. SNR to other AP's is 36 but you can see my speed and latency here. I have 1Gb up and down...
0HELPFULS
Forums/ WiFi
2020-04-30 23:25:08
Re:EAP245 V3 slow speeds after running for few hours
@R1D2 I was under the impression if the neighbour wifi's are sharing the same channels (fully overlapping) they take take turns and behave better VS if they are half overlapping they are fighting for...
0HELPFULS
12