@IrU3 Can you do the following test: Connect AX3000 WAN port to Archer C60 LAN port and check its status. Most probably there's some kind of incompatibility between the ONT port and the AX3000 WAN...

@Lilimog For some reason your RE is not connecting to the router: Go over the setup procedure again. Do you see any error messages during the procedure ? If this persists, may be something gone wrong...

@sriramb98 For this setup you should ask your question in BSNL community. The error message: " The IP address and the LAN IP address cannot be in the same subnet. Please enter another one" is pretty...

@OneMeshOnTop Keep an eye on this thread for a new anouncements - TP-Link development team most probably works on that.

@IrU3 Use another ethernet cable (CAT5E or above) between ONT and AX3000. Sometimes the cable can cause such an issue. You may try the ethernet cable from one of the routers' kits - it should be...

@Lilimog Reset the RE to its factory defaults by pressing teh reset button for about 10 seconds. Move it to your old location and start setting it up. Use this guide for connecting to a Starlink -...