@cs49 cs49 wrote 2 Questions about AP mode: 1. Should the connection to the main router be made through the WAN port? 2. Will the LAN ports act as a switch in AP mode? Thanks in advance . 1. In case...

@vesko41 Upon successful reset procedure ("Press and hold this button for 2 seconds until all LEDs turn off to reset the router to its factory default settings") the C50 factory defaults are: The...

@dIaBoLyK That's not possible, because it's a limitation hard-coded in the router's FW. This limit has been implemented, probably based on the router's HW limitation (chipset model, memory, etc.). If...

@RavinderGandhi Lower value (-78dBm < -73dBm) means, it picks weaker wireless signal => better coverage. Here's a full comparison between these two models. Some more details about wireless signal...

@.AV. Although Archer C6 is a gigabit router (1Gbps for each port) and there's no point to use higher than Cat5e to connect to another gigabit or faster device, you can use Cat8 as well. " One of the...

@Benibis It would be a good idea to post your WA1201 VLAN settings as well. Go through this example for using VLANs on TL-SG108E and then review/double-check your switches' settings. If you can't...