Setting up a new TL-SG108E switch and when I tried to put in a new password it would not accept the character @. However, TL-SG1016PE and TL-WA3001 both accept character @, no problem. Why does TL-SG1

Just got the new switch and during setup I changed from DHCP to static IP. At this point everything was still OK. I accessed the switch by the static IP and continued the configuration. At that time I

I have a detached garage with a workshop that I have connected with a powerline adapter. I am planning to run Cat 6 in the near future, so this question is only out of curiosity. I had an old TL-SG105